Determination of certain substances in electrotechnical products - Mercury in polymers, metals and electronics by CV-AAS, CV-AFS, ICP-OES and ICP-MS PAS 15 This standard has been aligned

This standard has been aligned

This part of IEC 60695 specifies a needle-flame test to simulate the effect of a small flame which may result from fault conditions

irradiation facilities and dosimetry

PD CEN/TS 14807 is a guidance document for use with a structural analysis procedure for below-ground installations

see BS EN ISO 3231

Determination of certain substances in electrotechnical products - Mercury in polymers, metals and electronics by CV-AAS, CV-AFS, ICP-OES and ICP-MS PAS 15 This standard has been aligned1 Scope This part of IEC 62321 describes test methods for mercury in polymers, metals and electronics by CV AAS, CV AFS, ICP OES and ICP MS. This standard specifies the determination of the levels of mercury (Hg) contained in electrotechnical products. These materials are polymers, metals and electronics (e. g. printed wiring boards, fluorescent lamps, mercury switches). Batteries containing Hg should be handled as described in [1]1. The